Polyurethane Conveyor Belts have excellent abrasion resistance, cut resistance and hydrolysis resistance.
Technical information
Image
We can work on all the coatings used in the belt and conveyor belt industry (polyurethane, PVC, rubber) with or without structure and on any type of support (flat, toothed, ribbed, V-belt or convey
Image
Guide rails and support rollers
It is recommended that grooved pulleys, support rollers and guide rails are used to hold the Belt in place to carry the load.
Image
What impact does the diameter of the Pulley have on the Belt?
Image
One of the pulleys must be crowned to ensure that the Belt stays properly on the pulleys.
Preferably one of the large Pulleys and/or with a large contact arc.
Image
Conical rollers
To prevent the Flat belt from slipping, at least one pulley must be partly tapered.
Image
Using the GeQo Drive tooth profile
GeQo Drive is an 8M belt with an STD tooth form optimised to reduce noise. The teeth are offset and the tooth profile slightly modified.
Image
Quick drive guide for Belt calculations
The table below provides information on the most important parameters for conveyor design based on belt thickness, material quality and applied pre
Image
Comparison of the different pitches of Synchronous timing belts
Not all pitches and tooth shapes of belts offer the same advantages.
Image
Comparison of Chains, Belts and Belts WITH ERO Joint® connectionsWhich is the best choice for transmitting power? :
Image
Technical information on Timing belts
The material and cabling of your Belt will depend on your application.