How do I fit ERO Joint® SK round and V-belts?

Cut the material approximately 120 mm longer than required.

The next step is to release the drive cable.

To do this, strip each side of the Belt.

The length of the sheath should be 10 mm less than the desired length.

Make a first knot with both ends.

You can apply a small dot of glue to secure the knot.

Then tie a second knot (as shown in the image, make it in the opposite direction to the first to secure the Belt).

Any wires hanging down should be cut off (in the event that the Belt has to be welded).

Continue reading.

Insert the knot into one of the two recesses in the Belt.

Using the EERGO (or MULTI TC) iron and the U-bolt, merge the Belt.

Use small pliers to trim off any excess material.